Allied-telesis AT-10408XP Instrukcja Użytkownika Pobierz pdf (Strona 36)

Chapter 2: Installation

Installing an XFP Transceiver

The AT-10408XP 10-Gigabit Ethernet Switch has eight XFP ports.

Note

The transceiver can be hot-swapped; you do not need to power off

the switch to install a transceiver. However, always remove the

cables before removing the transceiver.

Note

You must install the transceiver before you connect cables to it.

To install an XFP transceiver, perform the following procedure:

1. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

Warning

An XFP transceiver can be damaged by static electricity. Be sure to

observe all standard electrostatic discharge (ESD) precautions,

such as wearing an antistatic wrist strap, to avoid damaging the

transceiver.

2. Remove the dust plug from the XFP slot, as shown in Figure 12.

Figure 12. Removing the Dust Plug from the XFP Slot

3. Locate the label on the transceiver and turn it so that the label is on the

bottom.

XFP

STATUS

AULT

MASTER

PSU1

PSU2

10/100 LI

ACT

1000 LINK

ACT

TERMINAL PORT10/100/1000Base-T

BUSY

FAULT

1213

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 49 50

Brak uwag

Allied-telesis AT-10408XP Instrukcja Użytkownika Strona 36