Allied-telesis AT-MCF2000M Instrukcja Użytkownika Pobierz pdf (Strona 56)

Chapter 2: Installation

Starting a Local Management Session

To start a local management session on the chassis or

stack, perform the following procedure:

1. Connect the DIN-8 connector on the RS-232

Serial Management cable included with the

AT-MCF2000M Management Module to the RS-232

Terminal port on the management module, as shown in

Figure 20.

Figure 20. Connecting the RS-232 Serial Management

Cable to the RS-232 Terminal Port

2. Connect the DB-9 connector on the RS-232 Serial

Management cable to an RS-232 port on a terminal or

PC with a terminal emulator program.

3. Configure the terminal or terminal emulation program

as follows:

 Baud rate: 115200 bps (The baud rate of the

RS-232 Terminal port is adjustable from 9600 to

115200 bps. The default is 115200 bps. To adjust

the baud rate, refer to the AT-S85 and AT-S97

Management Software Command Line User’s

Guide.

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

1203a

AT-MCF2000M

STAC

10/100/1000BASE-T

DY BUS Y

POWE

BOOT

FAULT

000

T10

/100

LIN

ACT

T A

CTIV

ITY

AT-MCF2KFAN

NORMAL

FAULT

STATUS

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 69 70

Komentarze do niniejszej Instrukcji

Brak uwag

Allied-telesis AT-MCF2000M Instrukcja Użytkownika Strona 56

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Allied-telesis AT-MCF2000M