Allied-telesis AT-9448Ts/XP (Basic Layer 3) Instrukcja Użytkownika Pobierz pdf (Strona 44)

Chapter 2: Installing the Hardware

Installing the Switches in an Equipment Rack

Note

Installing a stack on a table or desktop is not recommended

because it may create a hazardous work area.

Perform the following procedure to install the switches in a standard

19-inch rack:

1. Place the switch upside down on a level, secure surface.

2. Using a flat-head screwdriver, remove the snap-on plastic feet from

the bottom of the switch, as shown in Figure 15.

Figure 15. Removing the Feet

3. Turn the switch over.

4. Attach a rack-mount bracket to one side of the switch using four of the

screws that come with the switch, as shown in Figure 16.

Figure 16. Attaching Rack-Mount Brackets

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 105 106

Brak uwag

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Instrukcja Użytkownika Strona 44