Allied-telesis AT-S62 Instrukcja Użytkownika Pobierz pdf (Strona 170)

100

101

Chapter 8: Port Parameter Commands

170

Description

This command sets a port’s operating parameters. You can set more

than one parameter at a time. For an explanation of the port parameters,

refer to the AT-S62 Management Software Menus Interface User’s Guide.

To configure the fiber optic port on a GBIC or SFP module in Port 49 or 50

of an AT-8550GB or AT-8550SP switch, the port must have a valid

connection to an end node. Otherwise, specifying Ports 49 and 50

configure the twisted pair ports 49R and 50R.

Examples

The following command disables ports 1 to 6:

set switch port=1-6 status=disabled

The following command configures port 8 to operate at 10 Mbps, half

duplex:

set switch port=8 speed=10mhalf

The following command sets the speed to 100 Mbps, the duplex mode

to full duplex, the wiring configuration to MDI-X, and flow control to

enabled for ports 2 to 6:

set switch port=2-6 speed=100mfull mdimode=mdix

flowcontrol=enable

The following command sets port priority to 5 and activates the

broadcast filter for ports 5, 8, and 12:

set switch port=5,8,12 priority=5

bcastfiltering=enabled

The following command resets port 5:

set switch port=5 softreset

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 572 573

Komentarze do niniejszej Instrukcji

Brak uwag

Allied-telesis AT-S62 Instrukcja Użytkownika Strona 170

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Allied-telesis AT-S62