Allied-telesis IE200 Series Instrukcja Użytkownika Pobierz pdf (Strona 41)

Chapter 2: Beginning the Installation

AT-IE200 Series Installation Guide 41

Selecting a Site for the Switch

The switch is designed for standalone or DIN rail mounting. Observe the following general requirements

when choosing a site for the switch:

 Install the switch close to the DC power supplies

 Verify that the site provides easy access to the ports on the front of the switch. This will

make it easy to connect and disconnect cables, as well as view the port LEDs.

 Check that the site allows for adequate air flow around the unit and through its vents on

the top and bottom. Air vents should not be restricted so that the switch can maintain

adequate cooling.

 Do not place objects on top of the switch.

 Do not expose the switch to moisture or water.

 You should use dedicated power circuits or power conditioners to supply reliable

electrical power to the network devices.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 69 70

Brak uwag

Allied-telesis IE200 Series Instrukcja Użytkownika Strona 41