Allied-telesis Removable Power Supply and Fan Instrukcja Użytkownika Pobierz pdf (Strona 13)

Removable Power Supply and Fan

2. Plug the AC power cord into the power inlet on the PSU.

3. Connect the power cord to the main power source.

4. Check that the Run/Standby switch is set to the Run position (1). Both the

AC and DC LEDs should be lit.

Note that when the Run/Standby switch is set to the Standby position (O),

the AC LED lights and the fan spins, but the DC LED does not light and the

PSU does not deliver power to the device.

5. The PSU LED on the front panel of the switch lights green. If the LED does

not light green, check the Run/Standby switch. See the Hardware Reference

for more troubleshooting information.

LED

RUN/STANDBY

SWITCH

CAPTIVE

SCREW

OUT

LED

FAULT

LED

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Brak uwag

Allied-telesis Removable Power Supply and Fan Instrukcja Użytkownika Strona 13