
SwitchBlade x8106 Chassis Switch Installation Guide
211
Replacing the AT-SBxPWRSYS1 DC Power Supply
To remove an AT-SBxPWRSYS1 DC Power Supply from the chassis,
perform the following procedure:
1. Turn off the circuit breaker to the AT-SBxPWRSYS1 DC Power
Supply.
2. Turn off the On/Off switch on the front panel of the power supply. Refer
to Figure 103 on page 152.
3. Use a #2 screwdriver to loosen the screw on the locking handle. Refer
to Figure 142.
Do not lift the locking handle yet.
Figure 142. Loosening the Screw on the Locking Handle
Komentarze do niniejszej Instrukcji