Allied Telesis Patch 1 AT-S63 Podręcznik Użytkownika Pobierz pdf (Strona 7)

AT-S63 Version 4.0.0 Patch 2 Software Release Notes

PN 613-001166 Rev A 7 Allied Telesis, Inc.

AT-9424T Switch

AT-9424T Switches shipped after March 2009 and having “04221” in their serial numbers must

use Version 4.0.0 or later of the AT-S63 Management Software. Downloading earlier versions of

the management software onto these switches causes them to fail during bootup.

Stacking Tips

 Stack Size

The maximum number of switches in a stack varies according to the switch model. A stack

can have up to eight units of AT-9424Ts Switches, AT-9424Ts/XP Switches or a combination

of both.

Stacks can also have the AT-9448Ts/XP Switch, but Allied Telesis does not recommend

using this model as a master switch. Consequently, a stack with one or more of these

switches should have an AT-9424Ts or AT-9424Ts/XP Switch acting as the master switch.

For stacks of more than three switches, both the master switch and the backup switch should

be 24-port switches. A stack should not have more than four AT-9448Ts/XP Switches and

should not exceed a total of eight units, as shown in this table.

 Adding switches to a stack. To add a switch to an existing stack, follow this procedure. (The

references are to Chapter 3, “Preparing the Switches of a Stack,” in the AT-9400 Stack

Installation Guide.)

1. Install the AT-StackXG Module in the switch. For instructions, refer to the Installation

Guide included with the module or Chapter 2, Installing the Hardware, in the AT-9400

Stack Installation Guide.

2. Verify that the new switch has the same version of the AT-S63 Management Software as

the other stack members. For instructions, refer to “Verifying the AT-S63 Version

Numbers.” If necessary, upgrade the unit’s software.

3. Assign the switch a static module ID number by performing the instructions in “Assigning

Status Module ID Numbers to the Member Switches.”

4. This step is optional. If you assigned the switch a stack ID number greater than 2, you

might want to consider configuring its parameter settings to match as closely as possible

its likely configuration when it is a part of the stack. Although the stand-alone

configuration of a switch is not transferred to its operations as a member of a stack,

configuring the switch for both stand-alone and stack operations might mitigate the impact

Number of 24-Port AT-9424Ts and AT-9424Ts/XP Switches

Number of

48-Port

AT-9448Ts/XP

Switches

012345678

Serial Number - x04221xxxxxxxxxx

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Brak uwag

Allied Telesis Patch 1 AT-S63 Podręcznik Użytkownika Strona 7