Allied Telesis x3100 Series Przewodnik Instalacji Pobierz pdf (Strona 12)

Copyright © 2010 Telesis, Inc. All rights reserved Information in this document is subject to change without notice.

12

Release PR Level Title Description

14.2.0 21260 2 Cannot filter IPv6

packets based on L4

fields (e.g. UDP/TCP

port #)

All L4 match rules mistakenly assume that

they must match IPv4 packets, and will not

match IPv6 packets. This has been fixed in

14.2. IPv6 packets are now classified when

applicable.

14.2.0 21053 2 Links with different

DIRECTION settings

are allowed in the

same LAG

The software mistakenly allows links with

different DIRECTION settings (e.g. one

CUSTOMER and one NETWORK) within

the same LAG. Until this is corrected, the

user should ensure that the settings are kept

the same. This has been fixed in 14.2 A

direction mis-match will prevent

port/interface from being added to the

LAG during CREATE LAG or ADD LAG

command processing.

14.2.0 20681 3 Redundant Counter

history entries in text

config output

Erroneous entries appear in the text config

output after COUNTER HISTORY

commands have been run. SET does not

remove the original entry (so a redundant

entry is created). DELETE does not

remove the original entry (so an erroneous

entry remains in text config file). This has

been fixed in 14.2. The customer should

now be able to display a valid range of

intervals or buckets or all buckets from the

CLI.

14.2.0 20360 3 Network interruption

hangs FTP

If a file is being transferred on to the

system via FTP and the connection to the

server is broken (by network failure or

administrative state change) then the

transfer hangs. If the file transfer is

stopped then the transfer remains in the

"Cancelled" status. No other file transfers

can take place. This has been fixed in

14.2.0. The system allows file transfer

using FTP to timeout correctly and to

release resources if the underlying physical

interface fails.

14.2.0 18891 3 DELETE

CLASSIFIER

INTERFACE=ALL

does not remove

classifier from LAG

interfaces

The command "DELETE CLASSIFIER ...

INTERFACE=ALL" does not remove

classifier from LAG interfaces. Until this is

corrected, the user must manually remove

classifiers from LAG interfaces with an

additional DELETE CLASSIFIER

command. This has been fixed in 14.2.0.

Adding a port to a lag will now copy over

the classifier configuration.

1 2 ... 7 8 9 10 11 12 13

Komentarze do niniejszej Instrukcji

Brak uwag