Allied Telesis AT-S80 Podręcznik Użytkownika Pobierz pdf (Strona 212)

Chapter 20: Quality of Service (QoS)

212 Section II: Using the Web Browser Interface

Changing the Temporary Priority Level of Untagged Traffic

This procedure explains how to change the temporary priority level of

untagged packets that enter a port, and so change the egress queue

where the packets are stored. For example, you could assign a temporary

priority value of 5 to the untagged packets received on a port so that the

packets are stored in queue 2 on the egress port. The default priority level

for untagged packets is 0.

To change the temporary priority level of untagged traffic received on a

port, perform the following procedure:

1. From the Advanced Config menu, select QoS Config and then select

Port Priority Config.

The Port Priority Configuration page is shown in Figure 63.

Figure 63. Port Priority Configuration Page

The columns in the menu display the following information:

Port

Displays the port number.

Trunk

Displays the trunk number if the port is a member of a trunk.

Traffic Class

Displays the temporary priority level applied to the untagged traffic that

enters the port. For example, in Figure 63 on page 212 the untagged

traffic received on port 2 is assigned a temporary priority level of 5.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 241 242

Brak uwag

Allied Telesis AT-S80 Podręcznik Użytkownika Strona 212