Allied-telesis AT-MC303 Instrukcja Użytkownika Pobierz pdf (Strona 21)

AT-MC300 Series Installation Guide

Planning the Installation

Please refer to the following guidelines when planning the installation.

❑

Both end nodes that will be connected to the two ports on the media

converter must operate at 100 Mbps.

❑

Both end nodes must operate in the same duplex mode, either half-

duplex or full-duplex, or they must be able to auto-negotiate the

duplex mode.

❑

The end node for the 100Base-TX twisted pair port can be a

workstation, a repeater, or a switch.

❑

The end node for the 100Base-FX fiber optic port can be a workstation,

a repeater, a switch, or another AT-MC300 Series Media Converter.

❑

Refer to Table 3 for the cabling specifications for the 100Base-TX

twisted pair port.

❑

Refer to Table 4 for the cabling specifications for the 100Base-FX fiber

optic port when operating in full-duplex mode.

❑

Refer to Table 5 for the cabling specifications for the 100Base-FX fiber

optic port when operating in half-duplex mode.

Table 3

Twisted Pair Cabling Specifications

Model Connector Cable Maximum Distance

All models RJ-45 Unshielded/Shielded Twisted Pair

Category 5 or better

100 m (328 ft)

Table 4

Fiber Optic Port Cabling Specifications - Full-duplex

Model Cable Maximum Distance

Maximum

Allowable Loss

Budget

All models 50/125 micron multimode

fiber optic cable

2 km (1.24 mi) 13.dB @ 1310 nm

All models 62.5/125 micron

multimode fiber optic

cable

2 km (1.24 mi) 16.8 dB @ 1310 nm

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Komentarze do niniejszej Instrukcji

Brak uwag

Allied-telesis AT-MC303 Instrukcja Użytkownika Strona 21

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Allied-telesis AT-MC303