Allied-telesis AT-RPS1000 Instrukcja Użytkownika Pobierz pdf (Strona 3)

AT-RPS1000 Installation

This document describes the features and procedures to install the

AT-RPS1000.

Summary of Features

The features of the AT-RPS1000 are as follows:

❑ Provides redundant, load-shared power for up to two gigabit

switches (AT-9108 or AT-8518).

If the primary power supply for the switch fails, the AT-RPS1000

takes over, ensuring uninterrupted network operation.

❑ Contains two active power supplies (each with its own AC power

connector) that share the load with the primary power supply

located in the gigabit switches.

❑ Provides status on power supply and fan operation of the

AT-RPS1000 by way of the gigabit switch’s Simple Network

Management Protocol (SNMP) and command-line interface (CLI).

Information regarding the AT-RPS1000 and fan operation can be

obtained by using the show switch command from the gigabit

switch CLI.

❑ Uses a standard 2U, 19-inch rack mount.

❑ Has 110/220 VAC autosensing capability.

❑ Capable of driving 3.3V at 20A and 5V at 10A on each of its DC

connectors.

❑ Supports only Allied Telesyn’s gigabit switches.

1 2 3 4 5 6 7 8 9

Brak uwag

Allied-telesis AT-RPS1000 Instrukcja Użytkownika Strona 3