Allied-telesis AT-S21 Instrukcja Użytkownika Pobierz pdf (Strona 23)

$70654#8VHU·V#*XLGH

2-7

&RQILJXULQJ#,3#3DUDPHWHUV

Skip this section if you have a non-TCP/IP network or if you have

TCP/IP but use a BootP or DHCP server to provide IP parameters.

This procedure provides the

minimum

IP configurations you need to

enter so that the switch can be part of your TCP/IP network.

Assigning a unique IP address to the switch provides an advantage:

the switch uses the same IP parameters despite resets and power

cycles.

1. Select System configuration>IP Parameters from the

main menu.

2. Select IP address, press

to insert a type-in field, and

enter a unique IP address for the switch.

3. Select Subnet mask and enter the switch’s subnet mask.

4. Select Gateway address and enter the address if you are

sending packets to another IP network.

The gateway address is the router that can forward packets to

the other IP networks.

Once the switch has an IP address, you may initiate Omega sessions

to it via Telnet or a web browser. Note that you can only have one

Telnet session operating at any one time. The session can be either

inbound or outbound. If you have an inbound session to Omega, you

do not have the option of starting a new session (outbound

connection). Therefore, if you are already using Telnet, the Omega

option Connect to a remote system will not be available

(described in detail in Chapter 4,

Monitoring and Administration

In addition, a local RS232 connection blocks a Telnet session and vice

versa.

For more on IP parameter configuration, go to Chapter 3 and refer to

the section,

IP Parameters

on page 3-2.

Note

For non-IP environments, you can use MAC addresses to connect to

remote Allied Telesyn switches as long as there are no routers

between the two switches. If you have assigned unique names, you

may use these in place of MAC or IP addresses.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 89 90

Brak uwag

Allied-telesis AT-S21 Instrukcja Użytkownika Strona 23