Allied-telesis AT-S21 Instrukcja Użytkownika Pobierz pdf (Strona 57)

$70654#8VHU·V#*XLGH

4-3

&RQQHFWLRQ#WR#D#5HPRWH#6ZLWFK#

Menu:

Administration>Connect to a remote system

This option allows you to use a switch to connect to and manage

another switch from Omega. This feature is only available if you are

connected to the switch for a local software management session

using the RS232 port.

1. Select Administration>Connect to a remote system.

2. Specify the switch by one of the following methods:

❑

By its user-assigned name enclosed in single quotes, in the

format

‘name’

❑

By its IP address, in the format

x.x.x.x

❑

By its Ethernet (or MAC) address, in the format

xxxxxx xxxxxx

The switch’s MAC address is printed above the switch’s RS232

management port on the front panel.

Once the information is validated and the connection to the

remote switch is opened, you immediately get that remote

switch’s Omega main menu. You may then use Omega to

configure the remote switch and run diagnostics.

The only option not available on the remote switch is

Connect to a remote system from the

Administration menu. The same is true if you used

Telnet.

3. Select Quit from the main menu when you are done.

Note

It is important that you select Quit after the Omega session.

Otherwise, you may block other sessions or software downloads via

the network to the remote switch. Refer also to Chapter 3,

Configuring Omega

, for information on using a timeout value.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 89 90

Brak uwag

Allied-telesis AT-S21 Instrukcja Użytkownika Strona 57