Allied-telesis AT-x510DP-52GTX Instrukcja Użytkownika Pobierz pdf (Strona 60)

Chapter 4: Installing the Switch and its Power Supplies

2. Remove the blank panel from the power supply slots on the rear panel

of the switch by unscrewing it, as shown in the following figure.

Figure 21. Removing the rear panel

3. Align the edges of the power supply module with the guides in the slot

and carefully slide the module into the chassis until it is flush with the

rear panel of the chassis, as shown below. Light pressure may be

needed to seat the module on the connector on the rear panel of the

chassis.

Caution

Do not force the power supply module into place. Doing so may

damage the connector pins on the backplane inside the chassis. If

there is resistance, remove the module and reinsert it after verifying

that the edges of the card are properly aligned in the guides in the

chassis’ module slot.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 128 129

Brak uwag

Allied-telesis AT-x510DP-52GTX Instrukcja Użytkownika Strona 60