Allied-telesis AT-9000 Series Instrukcja Użytkownika Pobierz pdf (Strona 74)

Chapter 2: Starting a Management Session

Saving Your

Changes

To permanently save your changes in the active boot configuration file,

use the WRITE command in the Privileged Exec mode:

awplus# write

You can also update the active configuration file with the COPY

RUNNING-CONFIG STARTUP-CONFIG command, also located in the

Global Configuration mode. It is just more to type.

awplus(config-if)# switchport access vlan 5

Add the ports as untagged ports to the

VLAN with the SWITCHPORT ACCESS

VLAN command.

awplus(config-if)# exit

Return to the Global Configuration mode.

awplus(config)# interface vlan5

Use the INTERFACE VLAN command to

move to the VLAN Interface mode of

VLAN 5.

awplus(config-if)# ip address dhcp

Activate the DHCP client on the switch

with the IP ADDRESS DHCP command.

awplus(config-if)# end

Return to the Global Configuration mode.

awplus# show ip interface

Verify the management IP address on the

switch.

awplus# show ip route

Verify the new management IPv4 address

and default gateway.

Table 4. Adding a Management IP Address: Example 2

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 147 148

Brak uwag

Allied-telesis AT-9000 Series Instrukcja Użytkownika Strona 74