Allied-telesis AT-FS970M Series Instrukcja Użytkownika Pobierz pdf (Strona 184)

Chapter 9: Port Parameters

184

Enabling or Disabling Ports

Disabling ports turns off their receivers and transmitters so that they

cannot forward traffic. You might disable unused ports on the switch to

protect them from unauthorized use, or if there is a problem with a cable or

a network device.

To disable ports, use the SHUTDOWN command in the Port Interface

mode. To enable ports again, use the NO SHUTDOWN command.

This example disables ports 1 to 4:

awplus> enable

awplus# configure terminal

awplus(config)# interface port1.0.1-port1.0.4

awplus(config-if)# shutdown

This example enables ports 17 and 22:

awplus> enable

awplus# configure terminal

awplus(config)# interface port1.0.17,port1.0.22

awplus(config-if)# no shutdown

For reference information, refer to “SHUTDOWN” on page 245 and “NO

SHUTDOWN” on page 219.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 192 193

Brak uwag

Allied-telesis AT-FS970M Series Instrukcja Użytkownika Strona 184