Allied-telesis AT-S97 Instrukcja Użytkownika Pobierz pdf (Strona 24)

Chapter 1: Starting a Command Line Management Session

SNMP Management Session

You can also manage the AT-MCF2000 chassis remotely using an Simple

Network Management Protocol (SNMP) management program such as

HP Openview. This method, however, does not use the management

interface.

To manage the chassis from a management workstation using an SNMP

management program, you need to load the Management Information

Base (MIB) file, atMCF2000.mib, that was included with the AT-S85 and

AT-S97 software onto the management workstation. (The MIB file is

available from the Allied Telesis web site.)

This requires that you use a MIB compiler to compile the file. A familiarity

with MIB objects is necessary for this type of management. To load the

MIB file onto a management workstation, follow the instructions included

with your MIB compiler. For instructions on how to compile the MIB file

with your SNMP program, refer to your SNMP management

documentation.

To establish a SNMP management session for a unit that is remotely

managed, the chassis must have a management card and an IP address.

Before performing the SNMP management session, note the followings:

 The 10/100Base-TX port on the management card must be connected

to the network.

 The remote management workstation must reach the chassis through

the subnet of the management card.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 253 254

Brak uwag

Allied-telesis AT-S97 Instrukcja Użytkownika Strona 24