Allied-telesis SwitchBlade Chassis and Fan Tray Instrukcja Użytkownika Pobierz pdf (Strona 5)

Quick Install Guide 5

C613-04029-01 REV C

Installing A Chassis

All AC and DC versions of this equipment must be earthed.

Follow these steps to install a chassis:

1. Read the safety information

The SwitchBlade Safety and Statutory Information booklet includes all

relevant safety information. A copy of the safety booklet is supplied with

each chassis. A PDF version can be found on the CD-ROM that ships with

every switch controller and every chassis, or can be downloaded from

www.alliedtelesyn.co.nz/support/switchblade/.

2. Gather the tools and equipment you will need

To install the chassis in a rack you will need a Phillips #2 screwdriver,

screws and cage nuts.

Due to the chassis’ size and weight, it is recommended that you have someone assist you

with the rack-mounting procedure.

3. Choose a suitable site for the switch

Either a stable flat surface or a 19 inch rack. For more information, see

“Selecting A Site” earlier in this guide.

4. Unpack the chassis and place it in its operating location

If installing the chassis in a rack:

• Ensure the rack has sufficient space for the chassis and its associated

cables.

• Check the rack-mounting brackets. The brackets can be front or mid

mounted.

• Install the rack crossbar in the rack, just below the chassis’ intended

position (see Figure 1 on page -6). The crossbar will support the chassis’

weight during installation.

• Mount the chassis in the rack. This step is easier and safer if performed

by two people.

1 2 3 4 5 6 7 8 9 10 11

Brak uwag

Allied-telesis SwitchBlade Chassis and Fan Tray Instrukcja Użytkownika Strona 5