Allied-telesis Telesyn AlliedView NMS System 9.0 Instrukcja Użytkownika Pobierz pdf (Strona 22)

Installing on a Windows Platform Initial Installation on a Front End Server

AlliedView NMS Installation Guide (Installing the AlliedView NMS - Distributed Front End

Server)

3-2

Note: The Front-End configuration is available only upon request. Please contact your Allied Telesis

representative for details.

Note: Anonymous FTP is used by the NMS to manage certain devices, and therefore must be

enabled on the Backend server. Refer to Appendix A for instructions.

3.2 Installing on a Windows Platform

Note: Prior to beginning the installation, obtain the IP address for the existing AlliedView NMS Back

End Server.

3.2.1 Initial Installation on a Front End Server

The software for a Front End server installation comes in a separate CD, and so can only be used to install a

Front End server. To install the AlliedView NMS Front End on a Windows platform, follow these steps:

1. Insert the Distributed Server Extensions installation CD-ROM in the CD-ROM drive. After approximately

60 seconds, the NMS InstallShield

Wizard Installer screen will appear.

2. On the Installer screen, click Next. This will display the license agreement page.

3. Carefully read the license agreement, click the I accept the terms of the license agreement radio button,

and then click Next.

Note: If you do not wish to proceed with the installation, click Cancel to exit.

The next screen, shown in the following figure, will specify the installation directory.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Brak uwag

Allied-telesis Telesyn AlliedView NMS System 9.0 Instrukcja Użytkownika Strona 22