Allied Telesis AT-iMG7x6MOD series Instrukcja Instalacji Pobierz pdf (Strona 19)

AT-iMG746MOD Installation Guide

Chapter 3: Installing the Gateway in the Enclosure 19

Connecting the Coax to the Home Network (if applicable)

With the HPNA card, the AT-iMG746MOD allows PCs, Set Top Boxes, VCRs, etc. to become members of

an ethernet subnet over the coax network that is already installed. Figure 9 shows an example. The coax-to-

ethernet converter can be purchased as ATI Part Number AT-iMG007.

Figure 9. Coax Network Configuration

To connect the coax cable, perform the following procedure:

1. Remove the grommet from the power cord entrance, cut a 1/4” “X” in it, and put it back in place.

2. Slip the coax through the grommet.

3. Connect the coax cable to the HPNA card, as shown in Figure 10.

4. Seal the grommet with tape and silicone and silicone sealant.

5. Tie-wrap the coax, using one of the secure posts or the bottom channel.

Figure 10. Connecting to coax cable

AT-iMG746MOD

as Master

Splitters are passive with

4-20 GHz range

Coax 25 to 35m

Coax 3 to 5m

1:4 Splitter

1:2 Splitters

Coax to ethernet

converter

1:2 Splitters

network_physical_coax.ai

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Brak uwag

Allied Telesis AT-iMG7x6MOD series Instrukcja Instalacji Strona 19