Allied Telesis Rapier 16Fi-FX Przewodnik Instalacji Pobierz pdf (Strona 5)

Software Version 2.9.1 5

Software Version 2.9.1

C613-10486-00 REV C

Release Licences

Release licences are valid for all releases for switches and routers manufactured

at the end of 2006. This means you can upgrade on these devices without

entering the enable release command.

If you already have a device, contact your Allied Telesis representative for

information about licencing. If you are not sure whether your device licence is

valid for all releases, use the following command:

show release

If your router or switch does not have the following output, contact your Allied

Telesis representative to request a licence.

A new release licence is not required when you are updating to a minor or

maintenance release. This change affects release licences only, and not special

feature licences.

Upgrading the GUI File

The naming convention for GUI resource files changed from Software Version

2.8.1 onwards. Names are now longer, and they include more information

about the router or switch model and software version to which the file

applies. For example, the GUI resource file for AT-9924 Series switches for

Software Version 291-01 is 9924_291-01_en_d.rsc.

Software versions before 2.8.1 do not recognise the new GUI name format. This

changes the upgrade process slightly.

Previous process With earlier software versions, you could upgrade the release file and the GUI

file at the same time, by using the following steps:

1. Load each file onto the router or switch.

2. Set both files as the preferred install files, by using the command:

set install=pref rel=new-rez-file gui=new-gui-file

3. Reboot the router or switch.

New process The first time you upgrade to a 2.9.1 version, you need to install the release

before the GUI, by using the following steps:

1. Load each file onto the router or switch.

2. Set the new release file as the preferred install file and uninstall the previous

GUI file, by using the command:

set install=pref rel=291-rez-file gui=

3. Reboot the router or switch.

4. Set the new GUI file as the preferred GUI file, by using the command:

set install=pref gui=291-gui-file

While the router or switch installs the GUI, the console is unresponsive. This

may take a minute.

Release Licence Period

-----------------------------------------------------

any full -

-----------------------------------------------------

1 2 3 4 5 6 7 8 9 10 ... 282 283

Komentarze do niniejszej Instrukcji

Brak uwag

Allied Telesis Rapier 16Fi-FX Przewodnik Instalacji Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Switche sieciowe Allied Telesis Rapier 16Fi-FX