Allied Telesis Switch AT-SBXPWRSYS1 Instrukcja Użytkownika Pobierz pdf (Strona 150)

Chapter 6: Installing the Transceivers and Cabling the Ports

150

6. Connect the fiber optic cable to the port on the transceiver, as shown

in Figure 107. The connector should snap into the port.

Figure 107. Attaching a Fiber Optic Cable to an XFP Transceiver in the

AT-SBx31XZ4 Line Card

7. Repeat this procedure to install additional XFP transceivers.

After installing and cabling the XFP transceivers in the AT-SBx31XZ4 Line

Cards, do one of the following:

 To install and cable additional transceivers, go to the appropriate

section in this chapter for instructions.

 After cabling all the ports in the chassis, go to Chapter 7,

“Powering On the Chassis” on page 153.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 221 222

Brak uwag

Allied Telesis Switch AT-SBXPWRSYS1 Instrukcja Użytkownika Strona 150