Allied Telesis Switch AT-SBXPWRSYS1 Instrukcja Użytkownika Strona 175

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 174
SwitchBlade x3112 Installation Guide
175
Connecting the
DC Power Wires
with the Right
Angle Terminals
To connect the DC power wires to the positive and negative terminals on
the power supply with the right angle terminals, perform the following
procedure:
1. Prepare adequate lengths of two stranded 8 AWG power wires by
stripping them as shown in Figure 124.
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
Figure 132. Stripping the Power Wires
You must use stranded wires with the terminal lugs. You may not
use solid wires.
2. Insert the power wires into the right angle terminals included with the
power supply and use a crimping tool to secure the wires to the
terminals. See Figure 133,
Figure 133. Attaching the Power Wires to the Right Angle Terminals
Przeglądanie stron 174
1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 221 222

Komentarze do niniejszej Instrukcji

Brak uwag