Allied Telesis Switch AT-SBXPWRSYS1 Instrukcja Użytkownika Pobierz pdf (Strona 168)

Chapter 7: Powering On the Chassis

168

Note

The right angle terminals require the removal of the plastic cover

from the terminal block.

You may also install the wires using bare wires.

Here are the procedures to wiring the positive and negative terminal block

on the power supply:

 “Connecting the DC Power Wires with the Straight Terminals” next

 “Connecting the DC Power Wires with the Right Angle Terminals” on

page 175

 “Connecting Bare DC Power Wires” on page 180

Connecting the

DC Power Wires

with the Straight

Terminals

To use the straight terminals to connect the DC power wires to the positive

and negative terminals on the power supply, perform the following

procedure:

1. Prepare adequate lengths of two stranded 8 AWG power wires by

stripping them as shown in Figure 124.

Warning

Do not strip more than the recommended amount of wire. Stripping

more than the recommended amount can create a safety hazard by

leaving exposed wire on the terminal block after installation.  E10

Figure 124. Stripping the Power Wires

Note

You must use stranded wires with the terminal lugs. You may not

use solid wires.

2. Insert the power wires into the terminals included with the power

supply and use a crimping tool to secure the wires to the terminals.

See Figure 125 on page 169.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 221 222

Brak uwag

Allied Telesis Switch AT-SBXPWRSYS1 Instrukcja Użytkownika Strona 168