Allied-telesis AT-MC102XLPCI Instrukcja Użytkownika Pobierz pdf (Strona 25)

AT-MC102XLPCI 100Mbps Media Converter Installation Guide

Pre-Installation Checklist

This is a pre-installation checklist for you to follow prior to installing the AT-

MC102XLPCI media converter in your computer chassis:

❒ Planning the Installation

❒ Unpacking the Media Converter

❒ Replacing the Bracket on page 27

❒ Configuring Auto-Negotiation on page 28

❒ Configuring MissingLink & Link Test on page 28

Planning the

Installation

Observe the following guidelines when planning the installation of your

media converter:

❒ The end-nodes connected to the media converter must

be configured for 100 Mbps

❒ If you choose to disable the Auto-Negotiation feature,

this must be done prior to installing the AT-

MC102XLPCI into the computer chassis. See

Configuring Auto-Negotiation on page 28 for more

information.

❒ If you choose to disable the MissingLink feature and

enable the Link Test feature, this must be done prior to

installing the AT-MC102XLPCI into the computer

chassis. See Configuring MissingLink & Link Test on

page 28 and Link Test on page 36 for more

information.

❒ Refer to Table 5, “Twisted-Pair Cable Requirements

for the 100Base-TX Ports” on page 38 for the twisted-

pair specifications.

❒ Refer to Table 8, “Fiber Optic Launch Power” on page

40 for the fiber optic port specifications.

Unpacking the

Media Converter

To unpack the AT-MC102XLPCI Media Converter, perform the following

procedure:

Warning

Wear a grounding device and observe electrostatic discharge

precautions when installing the network adapter card in a system.

Failure to observe this caution could result in damage to the card.

1. Remove all components from the shipping package.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Brak uwag

Allied-telesis AT-MC102XLPCI Instrukcja Użytkownika Strona 25