Allied-telesis AT-S95 CLI Instrukcja Użytkownika Pobierz pdf (Strona 169)

Power over Ethernet Commands

Page 157

Chapter 19.Power over Ethernet Commands

Note

The PoE commands are operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE

devices.

power inline

The port inline Interface Configuration (Ethernet) mode command configures the administrative mode of inline

power on an interface.

Syntax

power inline {auto | never}

Parameters

•

auto—Enables the device discovery protocol and, if found, supplies power to the device.

• never—Disables the device discovery protocol and stops supplying power to the device.

Default Configuration

The device discovery protocol is enabled.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example enables powered device discovery protocol on port 1/g1, so that power will be supplied to

a discovered device.

power inline powered-device

The power inline powered-device Interface Configuration (Ethernet) mode command adds a comment or

description of the powered device type to enable the user to remember what is attached to the interface. Use the

no form of this command to remove the description.

Syntax

power inline powered-device pd-type

Console(config)#

interface ethernet 1/g1

Console(config-if)#

power inline auto

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 347 348

Brak uwag

Allied-telesis AT-S95 CLI Instrukcja Użytkownika Strona 169