Allied Telesis Patch 86261-04 Instrukcja Użytkownika Strona 28

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 48
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 27
28 SHOW IGMPSNOOPING ROUTERADDRESS Patch Release Note
Patch 86261-09 for Software Release 2.6.1
C613-10388-00 REV J
Repeated Assert messages were sent after the prune limit expired. This issue
has been resolved. The default dense mode prune hold time has been
changed from 60 seconds to 210 seconds.
The ADD PING POLL command had a duplicate entry for the LENGTH
parameter in the dynamic PING configuration if LENGTH was not the
default value. This generated an incorrect configuration file when the
CREATE CONFIG command was executed. This issue has been resolved.
ISAKMP debug messages now correctly output IPv6 addresses when using
IPv6, and IPv4 addresses when using IPv4.
The IP version of packets was not being checked, so an IPv4 packet could
match an IPv6 IPSec policy. This issue has been resolved.
The following two issues have been resolved:
Large CRL files were not decoded correctly.
The certificate database was not validated immediately after the CRL
file was updated.
TCP Keepalive packets for FTP sessions were passing through the firewall
during the TCP setup stage with TCP Setup Proxy enabled. Keepalive
packets include sequence numbers that have already been acknowledged.
Such packets now fail stateful inspections and are dropped by the FTP
application-level gateway.
An anycast address could not be assigned when the prefix for the anycast
address had previously been assigned on that interface. This issue has been
resolved.
The ADD FIREWALL POLICY RULE and SET FIREWALL POLICY RULE
commands no longer accept the GBLREMOTEIP parameter with standard
NAT, or enhanced NAT for a private interface.
IPv6 used the same SA soft expiry timer at both ends of a link, which used
memory unnecessarily. This issue has been resolved.
When equal cost multipath routes were used, the IP option field for trace
route was not applied correctly. This issue has been resolved.
PCR: 03926 Module: PIM Level: 2
PCR: 03932 Module: PING Level: 3
PCR: 03935 Module: ISAKMP Level: 3
PCR: 03937 Module: IPSEC Level: 2
PCR: 03940 Module: PKI Level: 1
PCR: 03941 Module: FIREWALL Level: 2
PCR: 03954 Module: IPV6 Level: 2
PCR: 03958 Module: FIREWALL Level: 2
PCR: 03965 Module: IPSEC Level: 3
PCR: 03973 Module: IPG Level: 3
Przeglądanie stron 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Komentarze do niniejszej Instrukcji

Brak uwag