
34 SHOW IGMPSNOOPING ROUTERADDRESS Patch Release Note
Patch 86261-09 for Software Release 2.6.1
C613-10388-00 REV J
When broadcast packets were transmitted to one of two VLAN interfaces,
and a ping was sent to the other interface, 10% of the pings timed out. This
issue has been resolved.
In the output of SHOW FIREWALL EVENT command, the DIRECTION of
denied multicast packets was shown as “out”, not “in”. This issue has been
resolved.
When a boot file for DHCP was specified with the ADD DHCP POLICY
FILE command, a blank space was added after the filename in the
configuration. This meant the file could not be found. This issue has been
resolved.
When the device received a version 1 Query packet, it become a non-querier
on that interface, even if it should have remained as the querier. This issue
has been resolved.
When the preference value for RIPng was changed with the SET IPV6
ROUTE PREFERENCE command, the new value was not updated in the
IPV6 routing table. This issue has been resolved.
When the TYPE parameter was specified for the ADD SWITCH L3FILTER
command, the type was sometimes a different value in the device’s
hardware table. This issue has been resolved.
The etherHistoryIntervalStart node in the etherHistoryTable showed incorrect
values for the first and last 30 second interval periods. This issue has been
resolved.
A fatal error occurred if IPX was disabled and then re-enabled when there
was a high rate of incoming IPX traffic on the device. This issue has been
resolved.
In some circumstances FlashROM was corrupted. This issue has been
resolved. FlashROM is now write protected.
Rapier Series switches with a DC power supply did not recognise the DC
power supply. This issue has been resolved.
PCR: 31097 Module: SW56 Level: 2
PCR: 31099 Module: FIREWALL Level: 4
PCR: 31102 Module: DHCP Level: 2
PCR: 31106 Module: MLD Level: 2
PCR: 31110 Module: IPV6 Level: 2
PCR: 31118 Module: SWI Level: 2
PCR: 31122 Module: RMON Level: 3
PCR: 31129 Module: IPX2 Level: 2
PCR: 31130 Module: FFS Level: 2
PCR: 31137 Module: CORE Level: 4
Komentarze do niniejszej Instrukcji