Allied Telesis Patch 86261-04 Instrukcja Użytkownika Pobierz pdf (Strona 40)

40 SHOW IGMPSNOOPING ROUTERADDRESS Patch Release Note

Patch 86261-09 for Software Release 2.6.1

C613-10388-00 REV J

On AT-8800 series switches, strict QoS scheduling is now enforced for ports

where egress rate limiting is applied. On Rapier i series switches, the same

QoS setup is now applied to all of the appropriate ports when setting up

egress rate limiting.

When saving the IP filter configuration, non-default values for the source IP

address mask were not always saved correctly. This issue has been resolved.

On AT-8800 series switches, if a port was set to use 10 Mbps full duplex with

the SET SWITCH PORT SPEED=10MBFULL command, there was a delay

before the port was set. This delay has been minimised.

On AT-8800 series switches, the temperature at which a temperature alarm

is generated has been increased.

Uplink modules on Rapier series switches sometimes did not enable a link

correctly. This issue has been resolved.

Importing BGP routes into OSPF

Introduction With this enhancement you can import routes from BGP into OSPF. OSPF will

then redistribute these routes. This enhancement adds three parameters to the

set ospf command, and modifies the output of the show ospf command. The

new parameters are /jointfilesconvert/412162/bgpimport, /jointfilesconvert/412162/bgpfilter and /jointfilesconvert/412162/bgplimit.

BGP can learn thousands of routes, so it’s important to consider the network

impact of importing these routes. Routing devices in the OSPF domain may

become overloaded if they store too many routes. You can prevent this by

limiting the number of routes that will be imported.

Do not enable the importing of BGP routes into OSPF unless you are sure about

the consequences for the OSPF domain.

Enabling BGP route

import

To enable importing BGP routes into OSPF, use the command:

set ospf /jointfilesconvert/412162/bgpimport=on

Limiting the number

of routes

There are two ways to limit the number of BGP routes imported into OSPF.

One way is to specify a maximum number of routes with the command:

set ospf /jointfilesconvert/412162/bgplimit=1...300

PCR: 03953 Module: SW56 Level: 3

PCR: 03969 Module: IPG Level: 2

PCR: 03976 Module: SW56 Level: 3

PCR: 03979 Module: CORE Level: 3

PCR: 31037 Module: SW56 Level: 2

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Brak uwag

Allied Telesis Patch 86261-04 Instrukcja Użytkownika Strona 40