Allied Telesis Patch 86261-04 Instrukcja Użytkownika Strona 29

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 48
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 28
Patch 86261-09 For Rapier and AT-8800 Series Switches SHOW IGMPSNOOPING ROUTERADDRESS 29
Patch 86261-09 for Software Release 2.6.1
C613-10388-00 REV J
The IP filter blocked ping packets when the ACTION for these was set to
INCLUDE with the ADD IP FILTER command. This issue was caused by
the default SMASK value of 255.255.255.255, which blocked all incoming
packets. This issue has been resolved.
The SMTP proxy did not correctly filter sessions where messages were
fragmented. This had the potential to prevent the detection of third-party
relay attacks. This issue has been resolved.
Route flapping occurred if an interface went down and there was another
route to that interface’s next hop. This issue has been resolved.
The AUTHENTICATION parameter has been removed from the “?” CLI
help for firewall commands. This was not a valid parameter.
Port speed and duplex values set with the SET SWITCH PORT SPEED
command were sometimes not applied correctly. This issue has been
resolved.
Occasionally some firewall timers stopped early, resulting in sessions being
removed prematurely. Because of this, TCP Reset packets could be sent by
the firewall before TCP sessions were finished. This issue has been resolved.
When executing the SET DHCP POLICY, DELETE DHCP POLICY and
DESTROY DHCP POLICY commands, memory was not de-allocated
correctly. This issue has been resolved.
Sometimes the device rebooted when a severe multicast storm occurred due
to a loop in the network. This issue has been resolved.
The prune time limit was not being cancelled when an IGMP join was
received by the switch. This was forcing the switch to send a Graft message
in the upstream direction. This issue has been resolved by cancelling the
prune time limit whenever an IGMP Join is received.
If ports were set to a speed of 100m when creating a switch trunk, the speed
could not subsequently be set to 1000m, even if the ports were capable of
that speed. This issue has been resolved.
PCR: 03974 Module: IPG Level: 3
PCR: 03982 Module: FIREWALL Level: 3
PCR: 03986 Module: BGP, IPG Level: 2
PCR: 03993 Module: FIREWALL Level: 4
PCR: 03994 Module: SWI Level: 2
PCR: 03996 Module: FIREWALL Level: 2
PCR: 31001 Module: DHCP Level: 2
PCR: 31002 Module: UTILITY Level: 2
PCR: 31012 Module: PIM Level: 2
PCR: 31013 Module: SWI Level: 2
Przeglądanie stron 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Komentarze do niniejszej Instrukcji

Brak uwag