Allied-telesis AT-S94 CLI (AT-8000S Series) Instrukcja Użytkownika Pobierz pdf (Strona 268)

100

101

Page 267

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Parameters

This command has no arguments or keywords.

Default Configuration

PortFast mode is disabled.

Command Modes

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

This feature should be used only with interfaces connected to end stations. Otherwise, an accidental topology loop

could cause a data packet loop and disrupt device and network operations.

Example

The following example enables PortFast on Ethernet port 1/e15.

spanning-tree link-type

The spanning-tree link-type Interface Configuration mode command overrides the default link-type setting

determined by the duplex mode of the port and enables Rapid Spanning Tree Protocol (RSTP) transitions to the

forwarding state. Use the no form of this command to return to the default configuration.

Syntax

spanning-tree link-type {point-to-point | shared}

no spanning-tree spanning-tree link-type

Parameters

•

point-to-point —Indicates that the port link type is point-to-point.

• shared — Indicates that the port link type is shared.

Default Configuration

The device derives the port link type from the duplex mode. A full-duplex port is considered a point-to-point link

and a half-duplex port is considered a shared link.

Command Modes

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

There are no user guidelines for this command.

console(config)# interface ethernet 1/e15

console(config-if)# spanning-tree portfast

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 401 402

Komentarze do niniejszej Instrukcji

Brak uwag

Allied-telesis AT-S94 CLI (AT-8000S Series) Instrukcja Użytkownika Strona 268

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Allied-telesis AT-S94 CLI (AT-8000S Series)